3D Scanning & Reverse Engineering an AircraftCreating a 3D CAD Model of Dassault Falcon F10
THE PROBLEM A large aerospace company wished to retrofit an existing aircraft, the Dassault Falcon 10, with new aftermarket equipment. In a case such as this, manufacturing information is often impossible to obtain from the OEM. Furthermore, because production of the Falcon 10 ceased in 1989, there is a very small chance that 3D data of the plane even exists. To make matters worse, although the plane structure may have been designed to have rather uniform spacing and continuous geometry, following the assembly process, flight hours logged, and the effects of the aircraft sitting under its own weight cause features to twist and shift out of place from their original intent.
Falcon F10 Prepped for 3D Scanning
TRADITIONAL METHOD Traditionally, engineers must physically take hand measurements of the entire plane, or whichever section(s) they wish to reproduce. These would then be used to create 2D drawings or 3D models from which the company could work. Unfortunately plane outer geometry is very organic in nature and rather featureless, leaving the engineer with little geometry to accurately use as a reference. The interior of the aircraft is extremely complex with their complex truss structure, air ducts, wiring, and many other features that must be defined so as to work around them.
Falcon F10 Exterior 3D Scan Data
NEOMETRIX SOLUTION To capture the exterior of the plane, the Faro Focus long-range scanner was chosen for its ability to cover a lot of area in a relatively short period of time. Scans were taken in many different positions around the plane, including shots from above with the use of a lift. The full interior was also scanned with the Focus for general feature layout.
Falcon F10 Interior Scan Data
For the various internal components, the Creaform Metrascan handheld system was chosen due to its unique ability to take accurate measurements in harsh metrology environments. It’s wide temperature working range, and capability to track the part even when under vibration or movement made it perfect to scan directly in the hangar.
Escape Hatch 3D Scan Data
Upon completion of the on-site scanning, all scans were aligned in Geomagic Design X reverse engineering software. This allowed the exterior of the plane, and all individual components to be modeled in Design X to the correct aircraft coordinates requested by the customer.
Escape Hatch CAD Model
NEOMETRIX ADVANTAGE Utilizing 3D scanned data is decidedly the fastest method to reverse engineer an aircraft. The ability to capture 100% of the surface geometry of the plane is a clear advantage to attempting tedious measurements around and inside the body of the aircraft. Scan data will show every contour, stringer, air duct, and any other feature present within the scanner’s line of sight. If taking measurements using any other method, every component must be measured and recorded individually. Additionally, there is no real method of checking the accuracy of these measurements.
Falcon F10 CAD Model
The aircraft interior is very intricate and complicated. If outfitting these areas with aftermarket accessories, having a 3D scan available gives the engineer a much clearer picture of what is going on. One can easily see interferences and other complications when designing in a 3D environment that may not be so clear when only relying on recorded dimensions and drawings.